Denon DRA-F101 User Manual download pdf (Page 5)

ENGLISH

CONNECTING THE ANTENNAS

Installing the FM indoor antenna

Tune in FM station (see page 13), set the antenna so that

distortion and noise is minimal, then secure the tip of the

antenna in this position using tape or a pin.

Installing the AM loop antenna

Tune in an AM station (see page 13) and set the antenna

as far from the system as possible to keep distortion and

noise is minimal. In some cases, it is best to invert the

polarities. AM broadcasts cannot be received well if the

loop antenna is not connected or if it is set close to metal

objects.

AM LOOP ANT.

ANTENNA

FM COAX.

FM antenna

AM loop antenna

Installing an AM outdoor antenna

Connect the signal wire from the AM outdoor antenna to

the antenna terminal. Be sure to connect the signal

ground wire to the terminal. Also be sure to connect

the included AM loop antenna.

AM LOOP ANT.

ANTENNA

Signal ground

AM outdoor antenna

Assembling the AM loop antenna

Connect to the AM

antenna terminals.

Bend in the reverse

direction.

Remove the vinyl tie

and take out the

connection line.

Installation hole

Mount on wall, etc.

Mount

a. With the antenna

on top any stable

surface.

b. With the antenna

attached to a wall.

AM loop antenna

Connecting an FM outdoor antenna

If good reception cannot be achieved with the included

FM antenna, use an FM outdoor antenna. Connect an IEC-

type connector to the coaxial cable and connect the

antenna to the FM COAX (75 Ω/ohms) terminal.

Selecting a place for the FM outdoor antenna

• Set the antenna so that it points towards the broadcast

station’s transmitting antenna. Behind buildings or

mountains, set the antenna in the position at which

reception is best, and also try changing the direction of

the antenna.

• Do not install the antenna under power lines.

Doing so is extremely dangerous, as the power line

could touch the antenna.

• Install the antenna away from roads or train tracks to

avoid noise from cars or trains.

• Do not install the antenna too high, as it may be hit by

lightning.

BEFORE USING

Read the following before using the set.

• Before turning on the power

Check again that all connections are correct and that

there are no problems with the connection cords. Be

sure to unplug the power cord before connecting or

disconnecting the connection cords.

• Moving the set

To prevent short-circuits or damage to the connection

cords, always unplug the power cord and disconnect

the connection cords between all other audio

components when moving the set.

• Store this instructions in safe place

After reading, store this instructions along with the

warranty in a safe place. Also fill in the items on the

back paper for your convenience.

• Illustrations in this manual

Note that some of the illustrations used for

explanations in this manual may differ from the actual

set.

1 2 3 4 5 6 7 8 9 10 ... 36 37

Comments to this Manuals

No comments

Denon DRA-F101 User Manual Page 5

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon DRA-F101