Denon AVR-4802R User Manual download pdf (Page 35)

Preset memory

2, 3

DVD

Press the power ON/SOURCE button and the OFF button at

the same time.

•“PRE” appears on the remote control unit’s display.

The “SEL” indicator flashes and the device selection mode is

set.

Use the • and ª cursor buttons to display the mode you want

to preset, then press the ENTER button.

The display switches as shown below each time the • and

ª cursor buttons are pressed.

Use the • and ª cursor buttons to display “PRE” on the

remote control unit, then press the ENTER button.

The remote control unit’s display switches as follows each

time the • and ª cursor buttons are pressed.

“OK” is displayed when the signals are registered and the

mode is terminated.

Referring to the included List of

Preset Codes, use the number

buttons to input the preset code (a

4-digit number) for the

manufacturer of the component

whose signals you want to store in

the memory.

To store the codes of another component in the memory,

repeat steps 1 to 5.

The preset codes are as follows upon shipment from the factory and after resetting:

TV, VCR1......................................................................HITACHI

CD, MD, TAPE, CDR, VDP, DVD..................................DENON

VCR2, DBS...................................................................SONY

CABLE..........................................................................ABC

NOTES:

• Depending on the model and year of manufacture, this function cannot be used for some models, even if the your device is listed on the

included list of preset codes.

• Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and

check it out.

• For the CDR/MD, DBS/CABLE, VCR1/VCR2 and DVD/VDP modes, the unused mode can be deleted.

To delete an unused mode, select the mode to be deleted when registering the preset memory, input preset number “9999”, then press the

ENTER button.

For example, when the MD mode is deleted, only the CDR mode is displayed when the CDR/MD button is pressed.

This setting can be cancelled by resetting the preset memory or registering another preset signal.

The included remote control unit can be used to operate devices of different brands by registering the preset number corresponding to the brand

of your device.

For some models the remote control unit or the device may not operate properly. In this case, use the learning function (page 38) to store your

device’s remote control signals in the included remote control unit.

For instructions on resetting the preset memory, see page 41.

456

789

PRE

LRN

CALL

PUNCH

BKLT

RST

CD CDR

TAPE

DVD

VDP

VCR1

CABLE

DBS

VCR2

It is also possible to select the mode directly using the

mode buttons.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 89 90

Comments to this Manuals

No comments

Denon AVR-4802R User Manual Page 35

Comments to this Manuals

Related products and manuals for Receiver Denon AVR-4802R