Denon AVR-4802R User Manual Page 6
- Page / 90
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
6
5
CONNECTIONS
• Do not plug in the AC cord until all connections have been completed.
• Be sure to connect the left and right channels properly (left with left,
right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use them
for hair driers, etc.
• Note that binding pin plug cords together with AC cords or placing them
near a power transformer will result in generating hum or other noise.
• Noise or humming may be generated if a connected audio equipment
is used independently without turning the power of this unit on. If this
happens, turn on the power of the this unit
.
Connecting the audio components
• When making connections, also refer to the operating instructions of the other components.
SPEAKER SYSTEMS
PRE OUT
DVD TV MONITOR
YP
B/CB PR/CRYPB/CB PR/CRYPB/CB PR/CRYPB/CB PR/CR
COMPONENT
VIDEO
DBS/
SAT
ANTENNA
AUDIO
DIGITALEXT. IN
FRONT
LOOP ANT.
AM
CENTER
FM COAX. 75Ω
FR FL
SW C
SR SL
SBR SBL
SURROUND
-A
R
R
SURROUND
-B
SIGNAL
GND
PHONO
CD
FRONT CENTER SB
SW
SURROUND
DVD
DVD VDP TV DBS/
SAT
V. AUX VCR-1 VCR-2 VCR-3 VCR-1 VCR-2 VCR-3
S-VIDEO
VIDEO
1-
MONITOR
-2
VDP TV
IN OUT IN
IN OUT RS-232C
OUT
PRE OUT
SPEAKER
IMPEDANCE
FRONT, CENTER,
SB / MULTI
SURROUND
A OR B
6~16Ω
6~16Ω
8~16Ω
A + B
DBS/
SAT
CDR/
TAPE
CDR/
TAPE
MULTI
ZONE
V. AUX VCR-1 VCR-2
COAXIAL
123123 45 54
OPTICAL
VCR-3 VCR-1 VCR-2 VCR-3
R
SB / MULTI
ROOM TO ROOM
POWER
AMP
OUT
OUT IN
R
R
L
R
L
R
L
IN
IN IN IN OUT
OUT OUT
SPEAKER SYSTEMS
AC OUTLETS
AC IN
SWITCHED TOTAL 120W (1A) MAX.
AV 120V 60Hz
FRONT
SURROUND
-A
L
L
SURROUND
-B
L
SB / MULTI
L
REMOTE CONTROL
R
OUTPUT
L
R
L
DIGITAL AUDIODIGITAL AUDIO
RLRL
OUTPUT INPUT
RLRL
OUTPUT INPUT
OPTICALCOAXIAL
OUTPUT
OPTICAL
DIGITAL AUDIODIGITAL AUDIO
B
R
L
RL
R
L
RL
B
CD player
Connecting a CD player
Connect the CD player’s analog
output jacks (ANALOG OUTPUT)
to this unit’s CD jacks using pin
plug cords.
Connecting a turntable
Connect the turntable’s output cord to the AVR-4802R’s PHONO jacks,
the L (left) plug to the L jack, the R (right) plug to the right jack.
NOTE:
This unit cannot be used with MC cartridges directly. Use a
separate head amplifier or step-up transformer.
If humming or other noise is generated when the ground wire is
connected, disconnect the ground wire.
Turntable
(MM cartridge)
Ground wire
Extension jacks for future use
AC cord
(Supplied)
Connecting the pre-out jacks
Use these jacks if you wish to connect external power amplifier(s) to
increase the power of the front, center, surround and surround back
sound channels, or for connection to powered loudspeakers.
When using only one surround back speaker, connect it to left
channel.
Connecting the AC OUTLETS
AC OUTLETS
• SWITCHED
(total capacity – 120 W (1 A.))
The power to these outlets is turned on and off in conjunction with
the POWER switch on the main unit, and when the power is
switched between on and standby from the remote control unit.
No power is supplied from these outlets when this unit’s power is at
standby. Never connect equipment whose total capacity is above 120
W (1 A.)
NOTE:
Only use the AC OUTLETS for audio equipment. Never use them for
hair driers, TVs or other electrical appliances.
AC outlets (wall)
AC 120V, 60Hz
MD recorder, DAT deck or other component
equipped with digital input/output jacks
CD player or other component
equipped with digital output jacks
Connecting the DIGITAL jacks
Use these for connections to audio equipment with digital output. Refer
to page 28 for instructions on setting this terminal.
NOTES:
• Use 75 Ω/ohms cable pin cords for coaxial connections.
• Use optical cables for optical connections, removing the cap before connecting.
Connecting a tape deck
Connections for recording:
Connect the tape deck’s recording input jacks (LINE IN or REC) to this unit’s
tape recording (OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck’s playback output jacks (LINE OUT or PB) to this unit’s
tape playback (IN) jacks using pin plug cords.
CD recorder or Tape deck
- WARNING: 2
- ATTENTION 2
- SAFETY INSTRUCTIONS 3
- TABLE OF CONTENTS 4
- BEFORE USING 4
- CAUTIONS ON INSTALLATION 4
- CAUTIONS ON HANDLING 5
- FEATURES 5
- R/CR, PB/CB) 5
- CONNECTIONS 6
- Connecting video components 7
- Connecting a monitor TV 8
- Connecting the video decks 8
- VIDEO OUT 9
- COMPONENT 9
- VIDEO IN 9
- AM loop antenna assembly 10
- Connection of AM antennas 10
- INFRARED SENSOR 11
- Protector circuit 12
- Note on speaker impedance 12
- Connections 13
- PART NAMES AND FUNCTIONS 14
- Remote control unit 15
- SETTING UP THE SYSTEM 16
- SB SB SB SB 17
- Before setting up the system 18
- Setting the type of speakers 18
- Crossover frequency 20
- Setting the Subwoofer mode 20
- Setting the delay time 21
- Setting the channel level 23
- FL C FR SR SBR SBL SL SW 24
- Adjusting the audio delay 30
- Auto tuner presets 31
- Protecting the settings 31
- After completing system setup 32
- REMOTE CONTROL UNIT 33
- Inserting the batteries 33
- Preset memory 35
- 6,7 : Manual search 37
- 2 : Stop 37
- 3 : Pause 37
- Learning function 38
- 1, 4, 81, 4, 8 38
- System call 39
- Punch Through 40
- Resetting 41
- OPERATION 46
- Playing the input source 47
- MASTER VOLUME 48
- (Main unit) 49
- (Remote control unit) 49
- After starting playback 50
- IN=V SOURCE 51
- RECOUT SOURCE 52
- M-ZONE SOURCE 53
- ANOTHER ROOM MAIN ROOM 54
- (ON-OFF) 54
- AVR-4802R 55
- CONTROL UNIT 55
- SURROUND 56
- Fader function 57
- INPUT MODE 59
- PARAMETER 59
- Checking the input signal 61
- INPUT SELECTOR 62
- DIAL.NORM 63
- OFFSET + 4dB 63
- Dolby Surround Pro Logic 64
- II Mode: 65
- DTS Neo:6 mode 66
- Adjusting the Audio Delay 67
- DENON ORIGINAL SURROUND MODES 68
- DSP surround simulation 69
- Tone control setting 70
- Surround modes and parameters 71
- LISTENING TO THE RADIO 73
- Checking the preset stations 74
- LAST FUNCTION MEMORY 75
- TROUBLESHOOTING 76
- ADDITIONAL INFORMATION 77
- Surround back speakers 78
- Speaker setting examples 79
- Surround 81
- 2 DTS-ES 83
- 2 DTS Neo:6 83
- SPECIFICATIONS 89
- Telephone: (03) 3837-5321 90
Related products and manuals for Receiver Denon AVR-4802R
Receiver Denon AVR-788 User Manual
(74 pages)
(74 pages)
Receiver Denon S-302 User Manual
(58 pages)
(58 pages)
Receiver Denon POA-A1HDCI User Manual
(124 pages)
(124 pages)
Receiver Denon AVC-A1XV User Manual
(70 pages)
(70 pages)
Receiver Denon AVR-1507 User Manual
(64 pages)
(64 pages)
Receiver Denon AVR-688 User Manual
(68 pages)
(68 pages)
Receiver Denon AVR-3313CI User Manual
(10 pages)
(10 pages)
Receiver Denon AVR-4308 User Manual
(116 pages)
(116 pages)
Receiver Denon AVR-5308CI User Manual
(132 pages)
(132 pages)
Receiver Denon AVR-985SP User Manual
(2 pages)
(2 pages)
Receiver Denon AVR-3310 User Manual
(2 pages)
(2 pages)
Receiver Denon AVR-E200 User Manual
(12 pages)
(12 pages)
Receiver Denon AVR-3313CI Specifications
(24 pages)
(24 pages)
Receiver Denon DRA-F109 Owner's Manual
(14 pages)
(14 pages)
© 2020, manymanuals.com. All rights reserved. | 1.297 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals