Denon AVR-1907 User Manual download pdf (Page 60)

ENGLISH

Advanced Setup – Part 2Advanced Setup – Part 2

¢ Adjusting the test tone using the remote control

unit

Adjustment of the test tones using the remote control unit is only

possible in the “Auto” mode and only valid in the STANDARD (Dolby/

DTS Surround) mode. The adjusted levels are automatically stored for

the different surround modes.

Press [TEST TONE].

•Test tones are output from the different speakers.

Press [TEST TONE].

Press

FF GG

to adjust the volume.

Setting the Crossover Frequency

Set the frequency (Hz) below which the bass sound of the various

speakers is to be output from the subwoofer.

For speakers that are set to “Small”, frequencies under the crossover

frequency are cut before the signal is output, and the low frequency

component that was cut is output from the subwoofer or the

speakers that are set to “Large”.

Press

DD HH

to select “Crossover Frequency”, then

press ENTER.

Press

FF GG

to set.

40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:

Set as desired according to your speakers’ bass playback ability.

Press ENTER.

•The crossover frequency mode is valid only when subwoofer is set

to “ON”, and when one or more speakers are set to “Small”, as

described in section “Setting the Speaker Configuration” ( page

54, 55).

• If “LFE+Main” is set at “Subwoofer Setup”, “SW:LFE+Main” (

page 55) is displayed at the top right of the screen.

• Set to “80 Hz” when using regular speakers. When using small

speakers, we recommend setting to a higher frequency.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 73 74

No comments

Denon AVR-1907 User Manual Page 60