Denon AVR-2802/982 User Manual Page 38
- Page / 73
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
ENGLISH
38
Playback using the external input (EXT. IN) jacks
1
Set the external input (EXT.
IN) mode.
Press the EXT. IN to switch
the external input.
EXT.IN
EXT.IN
(Main unit) (Remote control unit)
Once this is selected, the input signals connected to the FL
(front left), FR (front right) and C (center) channels of the EXT.
IN jacks are output directly to the front (left and right) and
center speaker systems as well as the pre-out jacks without
passing through the surround circuitry.
In addition, the signal input to the SW (subwoofer) jack is
output to the PRE OUT SUBWOOFER jack.
2
Cancelling the external input mode
To cancel the external input (EXT. IN) setting, press the INPUT
MODE (AUTO, PCM, DTS) or ANALOG button to switch to
the desired input mode. (See page 36.)
INPUT MODE
ANALOG
INPUT MODE
ANALOG
(Main unit) (Remote control unit)
• When the input mode is set to the external input (EXT. IN), the play
mode (DIRECT, STEREO, DOLBY/DTS SURROUND, 5CH/6CH
STEREO or DSP SIMULATION) cannot be set.
NOTES:
• In play modes other than the external input mode, the signals
connected to these jacks cannot be played. In addition, signals
cannot be output from channels not connected to the input
jacks.
• The external input mode can be set for any input source. To
watch video while listening to sound, select the input source to
which the video signal is connected, then set this mode.
21
VOLUME LEVEL
AUTO
LOCK
STAND BY
DIGITAL
PCM
SIGNAL
DIGITAL
INPUT
REMOTE
SENSOR
B
SPEAKER
TUNING
BAND
TITLE
MENU/GUIDE
MODE
DOLBY / DTS
SURROUND
DIRECT
DSP SIMULATION
5CH / 6CH STEREO
STEREO
INPUT MODE
ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
MULTI
CDR/MDTAPE
SYSTEM
SETUP
SURROUND
PARAMETER
CH SELECT
SELECT
ENTER
2
1
After starting playback
[1] Adjusting the sound quality (tone)
The tone control function will not work in the direct mode.
1
The tone switches as follows each time the TONE CONTROL
button is pressed.
TONE
CONTROL
(Main unit)
2
With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.
SELECT
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –12 dB
in steps of 2 dB.)
VOLUME LEVEL
AUTO
LOCK
STAND BY
DIGITAL
PCM
SIGNAL
DIGITAL
INPUT
REMOTE
SENSOR
B
231
(Main unit)
BASS
1
TREBLE
1
3
If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
TONE DEFEAT
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.
- AVR-2802/982 1
- CAUTION: 2
- ATTENTION 2
- WARNING: 2
- SAFETY INSTRUCTIONS 3
- INTRODUCTION 4
- ACCESSORIES 4
- CAUTIONS ON HANDLING 5
- FEATURES 5
- CONNECTIONS 6
- Connecting video components 7
- AM loop antenna assembly 10
- Another room 11
- Protector circuit 12
- Note on speaker impedance 12
- !7!8!9@0@1@2@3@4@5@6@7 14
- Remote control unit 15
- SETTING UP THE SYSTEM 16
- Setting the type of speakers 17
- Before setting up the system 17
- Center Sp 18
- Front Sp 18
- Subwoofer 18
- Surround Sp 18
- Surround back Sp 18
- Setting the delay time 21
- Setting the channel level 22
- FL C FR SR 23
- Auto tuner presets 25
- After completing system setup 26
- REMOTE CONTROL UNIT 27
- SET CALL OFF 28
- “CDR/MD” 29
- (DIRECT) (STEREO) (EXT. IN) 29
- ON SCREEN 31
- Learning function 32
- System call function 33
- OPERATION 35
- Playing the input source 36
- ANALOGDIGITAL 37
- After starting playback 38
- VIDEO SELECT 39
- RECOUT SOURCE 40
- M-SOURCE SOURCE 40
- INTEGRATED 41
- AMPLIFIER 41
- SURROUND 42
- Dolby Surround Pro Logic 43
- MODE CINEMA 44
- INPUT MODE 45
- OFFSET - 4dB 46
- DSP SURROUND SIMULATION 47
- DSP surround simulation 48
- PARAMETER 49
- Tone control setting 50
- Surround parameters e 51
- Surround modes and parameters 52
- LISTENING TO THE RADIO 53
- Checking the preset stations 54
- Preset memory 54
- LAST FUNCTION MEMORY 55
- TROUBLESHOOTING 56
- ADDITIONAL INFORMATION 57
- Surround back speakers 58
- Speaker setting examples 59
- Surround 60
- DTS Digital Surround 61
- DTS-ES Extended Surround 62
- SPECIFICATIONS 65
- Telephone: (03) 3584-8111 66
- SPEAKER CONFIGURATION 71
- DELAY TIME 72
- Channel Level 72
- Digital In Assignment 73
- On Screen Display 73
- Auto Tuner Presets 73
Related products and manuals for Receivers and Amplifiers Denon AVR-2802/982
(40 pages)
(0 pages)
(14 pages)
(0 pages)© 2020, manymanuals.com. All rights reserved. | 1.904 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals