Denon AVR-3300 User Manual Page 43
- Page / 62
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
RC-617
AVR-3300
RC-616
43
ENGLISH
Multi-source and multi-zone playback
MULTI ROOM MUSIC ENTERTAINMENT SYSTEM
• When the outputs of the MULTI SOURCE AUDIO OUT terminals are wired and connected to integrated amplifiers installed in other rooms,
different sources can be played in rooms other than the main room in which this unit and the playback devices are installed. (Refer to ANOTHER
ROOM on the diagram below.)
• When a sold separately room-to-room remote control unit (DENON RC-616, 617 or 618) is wired and connected between the main room and
another room, the remote-controllable devices in the main room can be controlled from another room using the remote control unit.
*
To control playback devices other than the ones above, either use that device’s remote control unit or preset a separately sold programmable
remote control unit.
NOTES:
• For the AUDIO output, use high quality pin-plug cords and wire in such a way that there is no humming or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.
MULTI ROOM MUSIC ENTERTAINMENT SYSTEM
ANOTHER ROOM MAIN ROOM
INTEGRATED
AMPLIFIER
PROGRAMMABLE
REMOTE
CONTROL UNIT
SYSTEM REMOTE
CONTROL UNIT RC-860
ROOM-TO-ROOM REMOTE CONTROL SYSTEM
(separately sold) control line
MULTI SOURCE AUDIO signal cable
SPEAKER cable
*
Refer to CONNECTIONS on pages 7 to 14.
Playback using the external input (EXT. IN) jacks
1
Set the external input (EXT.
IN) mode.
Press the EXT. IN to switch
the external input.
EXT.IN
EXT.IN
(Main unit) (Remote control unit)
Once this is selected, the input signals connected to the FL
(front left), FR (front right), C (center), SL (surround left) and
SR (surround right) channels of the EXT. IN jacks are output
directly to the front (left and right), center and surround (left
and right) speaker systems as well as the pre-out jacks
without passing through the surround circuitry.
In addition, the signal input to the SW (subwoofer) jack is
output to the PRE OUT SUBWOOFER jack.
When 8CH EXT. IN is selected, the input signals
connected to the EL (effect left) and ER (effect right) jacks
are output to the PRE OUT effect (left and right) jacks.
Refer to page 26 for setting the number of external input
channels.
2
Cancelling the external input mode
To cancel the external input (EXT. IN) setting, press the input
mode (AUTO, PCM, DTS) or ANALOG button to switch to the
desired input mode. (See page 38.)
ANALOG
DTS
AUTO
PCM
NPUT MODE
ANALOG
(Main unit) (Remote control unit)
• When the input mode is set to the external input (EXT. IN), the play
mode (DIRECT, STEREO, DOLBY/DTS SURROUND, 5CH STEREO
or DSP SIMULATION) cannot be set.
NOTES:
• In play modes other than the external input mode, the signals
connected to these jacks cannot be played. In addition, signals
cannot be output from channels not connected to the input
jacks.
• The external input mode can be set for any input source. To
watch video while listening to sound, select the input source to
which the video signal is connected, then set this mode.
SPEAKER
TUNING
BAND
TITLE
MENU/GUIDE
MODE
DOLBY / DTS
SURROUND
DIRECT
DSP SIMULATION
5CH STEREO STEREO
INPUT MODE
ANALOG EXT.IN
MUTING
MASTER VOL.
VOLUME DISC SKIP+
AVR/AVC VIDEO DVD TV
AUDIO
VDP VCR
CD
MD
MULTI
DECK
SYSTEM
SETUP
SURROUND
PARAMETER
CH SELECT
SELECT
ENTER
2
1
- AVR-3300 1
- CAUTION: 2
- ATTENTION 2
- WARNING: 2
- ENGLISHFRANCAIS 3
- SAFETY INSTRUCTIONS 4
- INTRODUCTION 5
- ACCESSORIES 5
- CAUTIONS ON HANDLING 6
- FEATURES 6
- CONNECTIONS 7
- Connecting video components 8
- BCB CRCRYCB CR 9
- 75 Ω/ohms COAXIAL CABLE 10
- Jacks (DVD Player) 11
- Another room 12
- Speaker system connections 13
- Protector circuit 14
- Note on speaker impedance 14
- PART NAMES AND FUNCTIONS 15
- Remote control unit 16
- SETTING UP THE SYSTEM 17
- Before setting up the system 19
- Setting the type of speakers 19
- Setting the bass output 20
- Setting the delay time 21
- Setting the channel level 23
- Setting the digital inputs 25
- EXT. IN & MULTI 26
- Auto tuner presets 27
- After completing system setup 28
- REMOTE CONTROL UNIT 29
- SET CALL OFF 30
- Preset memory 31
- (VCR-2/V.AUX) 32
- ON SCREEN 33
- Learning function 34
- System call function 35
- OPERATION 37
- Playing the input source 38
- ANALOG DIGITAL 39
- After starting playback 40
- RECOUT SOURCE 41
- M-SOURCE SOURCE 41
- FUNCTION 42
- NPUT MODE 43
- SURROUND 44
- Fader function 45
- Dolby Surround Pro Logic mode 45
- INPUT MODE 46
- DOLBY / DTS 46
- DIAL.NORM 47
- OFFSET - 4dB 47
- DSP SURROUND SIMULATION 48
- DSP surround simulation 49
- Tone control setting 51
- LISTENING TO THE RADIO 52
- Auto tuning 53
- Manual tuning 53
- Checking the preset stations 54
- LAST FUNCTION MEMORY 55
- TROUBLESHOOTING 56
- ADDITIONAL INFORMATION 57
- Speaker setting examples 58
- Surround 59
- DTS Digital Surround 60
- Surround modes and parameters 61
- SPECIFICATIONS 62
Related products and manuals for Receivers and Amplifiers Denon AVR-3300
(2 pages)
(2 pages)© 2020, manymanuals.com. All rights reserved. | 1.013 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals