Denon AVR-4806CI User Manual download pdf (Page 23)

Easy Setup and Operation

Perform step 2, 3 repeatedly.

The more measurement points, the better the

resulting room correction effect. We recommend a

minimum of 6 measurement points – 8 measurement

points provides the best room correction effect.

After measuring at the number of points

according to your listening environment, press

the

CURSOR

button to select

“Calculate”, then press the

CURSOR

button.

• The speaker system is analyzed.

The amount of time required for the analysis depends

on the number of speakers and the number of

measuring points. The greater the number of speakers

and measuring points, the longer the time required. For

example, for ten speaker systems and 6 measuring

points, the calculations require approximately 6

minutes.

Measurements can be ended when there are 5 or less

measurement locations; however, to obtain better

results, measurements at 6 or more locations is

recommended.

Once the calculations are completed, a screen for

confirming the results of the measurements appears.

Speaker system measurement

•With these measurements, the “Speaker Configuration”,

“Delay Time”, “Channel Level”, “Crossover Frequency” and

“Room EQ” are analyzed automatically. The main listening

position is measured first, so leave the microphone where it

is.

Press the CURSOR

button to select “OK

Start”, then press the

CURSOR

button.

• Measurements for the first point start.

The screen shown at the below appears once the

measurements for the main listening position are

completed.

Next the measurements for the second point

will be taken.

Place the microphone at the second listening position.

For instructions on the position in which the

microphone should be placed ( page 19).

NOTE:

• If the results are not as expected or if an error message is

displayed, select “Retry” and perform the measurements

again. (For details on the error messages ( page 25).)

If the results of remeasurement are still not as expected

or if an error message is displayed, turn off the power

switch and check the speaker connections. Then start the

measurements again from the beginning.

• Measurement is cancelled when MASTER VOLUME is

operated while the Auto Setup is performed.

Press the CURSOR

button.

• Measurements for the second point start.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 201 202

Comments to this Manuals

No comments

Denon AVR-4806CI User Manual Page 23

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-4806CI