Denon AVR-686 Operations Instructions download pdf (Page 13)

Easy Setup and Operation Easy Setup and Operation

• These errer displays may be displayed when performing Aute Setup measurement and the automatic measurements can not be

completed because ef the speaker arrangement, measurement envirenment, or other facters. Please check the follewing matters,

reset the pertinent items, and measure again.

• When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the

measurements when the noise level is low, or switch off the power of the equipment that is producing the noise for the duration

of the measurements.

C ._i_u i:: i o ii _ [:::=['_ ._i_:iii: _i!

r"_ ..m

,...: . :,.

C ._i_u i:: i o ii

0 _...'e _..1i.o .iii_,::l ::1E::.::i t:

_1};The speakers required fer producing suitable

reproduction have not been detected.

• The frent L or front R speaker was net

properly detected.

• Only one channel ef the surreund speakers

was detected.

• Sound was eutput from the R channel when

only one surreund back speaker was

connected.

• The surreund back speaker was detected, but

the surreund speaker was net detected.

_2}The speaker polarity is cennected in reverse.

_.: When accurate measurements cannot be

made due te the input level of the microphone

being too high.

• Check the polarity of the pertinent

speakers. Fer some speakers, this

display may be displayed even

though the speakers are properly

cennected. If se, select "Skip,".

• Set up the speakers se that their

position is farther away frem the

listening position.

• Lower the velume ef the subweofer

speaker.

Disconnect the microphone from the unit.

Select the play (surround) mode.

Start DVD playback.

Adjust the volume.

L ENGLISH J

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 60 61

No comments

Denon AVR-686 Operations Instructions Page 13