Denon AVP-A1HD Owner's Manual download pdf (Page 13)



Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpeciﬁcationsSetup

Auto Setup

When this unit is upgraded, the “Auto Setup”

contents are returned to the default settings.

When conﬁguring the “Auto Setup” settings, refer

to this version of the Owner's Manual instead of

the “Original version”.

The acoustic characteristics of the connected speakers and

listening room are measured and the optimum settings are made

automatically. This is called “Auto Setup”.

To perform measurement, place the setup microphone in multiple

locations all around the listening area. For best results, we

recommend you measure in six or more positions, as shown in

the illustration (up to eight positions).

• When performing Auto Setup, Audyssey MultEQ

XT 32/Dynamic

/Dynamic Volume

functions become active (vpage 41, 42).

• To set up the speakers manually, use “Manual Setup” – “Speaker

Setup”(vpage 23 ~ 25) on the menu.

NOTE

• Make the room as quiet as possible. Background noise can disrupt

the room measurements. Close windows, silence cell phones,

televisions, radios, air conditioners, ﬂuorescent lights, home

appliances, light dimmers, or other devices as measurements may

be affected by these sounds.

• Cell phones should be placed away from all audio electronics during

the measurement process as Radio Frequency Interference (RFI)

may cause measurement disruptions (even if the cell phone is not in

use).

• Do not unplug the setup microphone from the main unit until Auto

Setup is completed.

• Do not stand between the speakers and setup microphone or allow

obstacles in the path while the measurements are being made. This

will cause inaccurate readings.

• Loud test sounds may be played during Auto Setup. This is part of

normal operation. If there is background noise in room, these test

signals will increase in volume.

•Operating the MASTER VOLUME knob or main remote control

VOL +/– button during measurement cancels the measurement.

•Measurement cannot be performed when headphones are connected.

Before performing Auto Setup, disconnect the headphone plug.

About setup microphone placement

• Measurements are performed by placing the setup microphone

successively at multiple positions throughout the entire listening

area, as shown in GExample qH. For best results, we recommend

you measure in six or more positions, as shown in the illustration (up

to eight positions).

• Even if the listening environment is small as shown in GExample wH,

measuring at multiple points throughout the listening environment

results in more effective correction.

FL SW C FR

SBL SBR

FL SW C FR

SBL SBR

GExample qH GExample wH

( :Measuring positions) ( :Measuring positions)

: Front speaker (L)

: Surround speaker (L)

: Front speaker (R)

: Surround speaker (R)

: Center speaker

SBL

: Surround back speaker (L)

: Subwoofer

SBR

: Surround back speaker (R)

n About the main listening position (*M)

The main listening position is the position where listeners would

normally sit or where one would normally sit alone within the

listening environment. Before starting Auto Setup, place the

setup microphone in the main listening position. MultEQ

XT 32

uses the measurements from this position to calculate speaker

distance, level, polarity, and the optimum crossover value for the

subwoofer.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Comments to this Manuals

No comments

Denon AVP-A1HD Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for AV receivers Denon AVP-A1HD