Denon AVP-A1HD Owner's Manual download pdf (Page 22)



Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpeciﬁcationsSetup

Examples Error details Measures

AUTO SETUP

1 2 3 4 5 6

RETURN

Skip

SW Level Matching

The subwoofer's level is too high or low. Please select "SW

Level Matching" and adjust the level of your subwoofer unit.

If you do not want to use the

subwoofer, select "Skip".

Proceed to subwoofer volume adjustment item

Enter Cancel

Caution!

• Correct measurement is not possible due to inappropriate subwoofer

volume.

• When using a subwoofer with built-in ampliﬁer (active type), use

“SW Level Matching” to adjust the subwoofer volume (vpage 17

“Adjusting the subwoofer volume level”).

• When using a subwoofer without a built-in ampliﬁer, select “Skip”,

and then press ENTER.

AUTO SETUP

RETURN

Retry

No microphone or speaker

Check cause of problem!

Cancel

Caution!

• The connected setup microphone is broken, or a device other than

the supplied setup microphone is connected.

• Not all speakers could be detected.

• The front L speaker was not properly detected.

• Connect the included setup microphone to the SETUP MIC jack of

this unit.

• Check the speaker connections.

AUTO SETUP

RETURN

Retry

Ambient noise is too high

or Level is too low

Check cause of problem!

Cancel

Caution!

• There is too much noise in the room for accurate measurements to

be made.

• Speaker or subwoofer sound is too low for accurate measurements

to be made.

• Either turn off any device generating noise or move it away.

• Perform again when the surroundings are quieter.

• Check the speaker installation and the direction in which the speakers

are facing.

• Adjust the subwoofer’s volume.

AUTO SETUP

1 2 3 4 5 6

RETURN

Retry

Front R None

Check cause of problem!

Cancel

Caution!

• The displayed speaker could not be detected.

(The screen on the left indicates that the front right speaker cannot

be detected.)

• Check the connections of the displayed speaker.

AUTO SETUP

1 2 3 4 5 6

RETURN

Skip

Retry

Front R Phase

Check cause of problem!

Cancel

Caution!

• The displayed speaker is connected with the polarity reversed.

(The screen on the left indicates that the polarity phases of the front

right speakers are reversed.)

• Check the polarity of the displayed speaker.

• For some speakers, this error message may be displayed even if

the speaker is properly connected. If you are sure the connection is

correct, press ui to select “Skip”, then press ENTER.

Error messages

NOTE

• An error message is displayed if Auto Setup could not be completed due to speaker placement, the measurement environment, etc. Check the related items, and implement the necessary measures. After resolving

the error, perform Auto Setup again.

• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker

connections and repeat the measurement process from the beginning.

• Be sure to turn off the power before checking speaker connections.