24
ENGLISH
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as (described) below.
1
Select the speaker whose
level you want to adjust.
2
The channel switches as shown below each
time the button is pressed.
Adjust the level of the
selected speaker.
(Remote control unit)
NOTE:
• Please make sure the “AUDIO” position of
the slide switch on the remote control unit.
Default setting of channel level is 0 dB.
The level of the selected speaker can be
adjusted within the range of +12 to –12 dB
using the cursor buttons.
SW channel level can be turned off by
decreasing one step from –12 dB.
OFF ´ –12 dB ´ 12 dB
2
(Main unit) (Remote control unit)
• The Dolby Pro Logic II indicator lights.
Display Light
3
Play a program source with the mark.
• For operating instructions, refer to the manuals of the respective components.
Dolby Pro Logic
II
x (Pro Logic
II
) mode
1
Select the function to which the component
you want to play is connected.
The Dolby Surround Pro
Logic
II
x Cinema or Music
mode can be chosen
directly by pressing the
CINEMA or MUSIC button
on the remote control unit
during playback in the
Dolby Surround Pro Logic
II
x mode.
(Main unit) (Remote control unit)
(Remote control unit)
When the surround back speaker setting
is set to “1sp” for “Speaker Configuration”,
this is set to “SB”.
To play in the PL IIx mode, set “S.BackSp” at the Speaker Configuration setting to “1Sp” or “2Sp”.
Example: DVD
Select the Dolby Surround Pro Logic
IIx mode.
4
Select the surround parameter mode.
To perform this operation from the remote control
unit, check that the mode selector switch is set to
“AUDIO”.
(Main unit)
(Remote control unit)
Display
Comments to this Manuals