Denon AVR-4802R User Manual download pdf (Page 56)

SURROUND

Before playing with the surround function

• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment

can be performed with the system setup (see page 23) or from the remote control unit, as described below.

• Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only effective in the DOLBY/DTS

SURROUND and HOME THX CINEMA modes. The adjusted levels for the different modes are automatically stored in the memory.

Press the TEST TONE button.

Test tones are output from the

different speakers. Use the channel

volume adjust buttons to adjust so

that the volume of the test tones is

the same for all the speakers.

1, 3

After completing the adjustment,

press the TEST TONE button again.

(Remote control unit)

• After adjusting using the test tones, make the desired settings for each surround mode to be played, then use the procedure described below

to adjust the levels of the various channels.

MAIN UNIT:

Press the CH VOL button and select

“CH VOL”.

The channel switches in the following

order each time the button is pressed:

MAIN UNIT:

Turn the SELECT knob to adjust the

level of the selected speaker.

FL C FR SR SBR SBL

SLSW

FADER

CH VOL

(Main unit)

REMOTE CONTROL UNIT:

Select the speaker whose level you want

to adjust.

(Remote control unit)

SELECT

(Main unit)

REMOTE CONTROL UNIT:

Adjust the level of the selected speaker.

(Remote control unit)

When the surround back speaker setting is set to “1spkr” for

“Speaker Configuration”, this is set to “SB”.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 89 90

No comments

Denon AVR-4802R User Manual Page 56