Denon AVR-X510BT Owner's Manual download pdf (Page 88)

Bass

Set subwoofer and LFE signal range playback.

LPF for LFE

Set LFE signal playback range. Set this when you want to change the

playback frequency (low pass filter point) of the subwoofer.

80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz/ 150 Hz /

200 Hz / 250 Hz (Default : 120 Hz)

Subwoofer Mode

Select low range signals to be reproduced by subwoofer.

LFE:

The low range signal of the channel set to

“Small” speaker size is added to the LFE

signal output from the subwoofer.

LFE+Main

(Default):

The low range signal of all channels is

added to the LFE signal output from the

subwoofer.

“Subwoofer Mode” can be set when “Speaker Config.” -

“Subwoofer” (v

p. 86) is set to other than “No”.

Play music or a movie source and select the mode offering the strongest bass.

If “Speaker Config.” - “Front” and Center are set to “Large”, and “Subwoofer

Mode” is set to “LFE”, no sound may be output from the subwoofers,

depending on the input signal or selected sound mode. (v

p. 86) Select

“LFE+Main” if you want the bass signals to always be produced from the

subwoofer.

Contents Connections Playback Settings Tips Appendix

Front panel Display Rear panel Remote Index

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 126 127

No comments

Denon AVR-X510BT Owner's Manual Page 88