Denon AVR-786 User Manual download pdf (Page 50)

ENGLISH

Advanced Setup – Part 2 Advanced Setup – Part 2

Set the subwoofer mode according to the speaker system being

used.

Setting the SW Mode Setup

Press the CURSOR

button to select “SW

Mode Setup” at the “Speaker Setup” menu, then

press the ENTER button.

• The “Subwoofer Mode Setup” screen appears.

Press the CURSOR

button to select a

setting.

Press the ENTER button to enter the setting.

• The “Speaker Setup” menu appears.

Press the CURSOR

button to select

“Exit”, then press the ENTER button.

• The “System Setup” menu appears.

• This screen is not displayed when not using a subwoofer and

all speakers are set to small size.

2 Assignment of low frequency signal range

The only signals produced from the subwoofer channel are LFE

signals (during playback of Dolby Digital or DTS signals) and the

low frequency signal range of channels set to “Small” in the

setup menu. The low frequency signal range of channels set to

“Large” are produced from those channels.

2 Crossover Frequency

• When “Subwoofer” is set to “Yes” at the “Speaker Config.”

screen, set the frequency (Hz) below which the bass sound of

the various speakers is to be output from the subwoofer (the

crossover frequency).

• For speakers set to “Small”, sound with a frequency below

the crossover frequency is cut, and the cut bass sound is

output from the subwoofer instead.

(• When “Subwoofer” is set to “No”, the bass sound is output

from the speakers set as “Large”.)

NOTE:

• For ordinary speaker systems, we recommend setting the

crossover frequency to 80 Hz. When using small speakers,

however, setting the crossover frequency to a higher

frequency may improve frequency response for frequencies

near the crossover frequency.

2 Subwoofer Mode

• The subwoofer mode setting is only valid when “Large” is set

for the front speakers and “Yes ” is set for the subwoofer in

“Setting the Speaker Config.” ( page 44).

• When the “LFE+MAIN” playback mode is selected, the low

frequency signal range of channels set to “Large” is produced

simultaneously from those channels and the subwoofer

channel.

In this playback mode, the low frequency range expands more

uniformly through the room, but depending on the size and

shape of the room, interference may result in a decrease of the

actual volume of the low frequency range.

• Selection of the “LFE” play mode will play the low frequency

signal range of the channel selected with “Large” from that

channel only. Therefore, the low frequency signal range that is

played from the subwoofer channel is only the low frequency

signal range of LFE (only during Dolby Digital or DTS signal

playback) and the channels specified as “Small” in the setup

menu.

• Select the play mode that offers the fullest bass.

• When the subwoofer is set to “Ye s ”, bass sound is output from

the subwoofer regardless of the subwoofer mode setting in

surround modes other than Dolby/DTS.

• In surround modes other than Dolby Digital and DTS, if the

subwoofer is set to “Yes”, the low frequency portion is always

output to the subwoofer channel. For details, refer to

“Surround modes and parameters” ( page 56).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 67 68

Comments to this Manuals

No comments

Denon AVR-786 User Manual Page 50

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-786