Denon ADV-M71 User Manual download pdf (Page 44)

ENGLISH

Either turn the SURROUND/SELECT dial or press the

SURROUND button on the remote control unit to select the

surround mode.

SURROUND / SELECT

PUSH

PARAM.

SURROUND

Main unit Remote control unit

• The function switches as shown below.

• The function only changes in the “Æ” direction when

operated from the remote control unit.

DOLBY VS STEREO *AUTO DECODE

*5CH STEREO *MONO MOVIE

ROCK ARENA

DIRECT

JAZZ CLUB

DOLBY VS

VIDEO GAME *MATRIX

• The modes marked “*” can be selected when “5.1-

channel surround” is selected in the quick system setup.

Start playback on the selected component.

• For operating instructions, refer to the component’s

manual.

• The volume can be adjusted within the range –60 to 0 to

+18 dB. Note that depending on the input signal, surround

mode, speaker settings and channel level setting, it may

not be possible to adjust the volume up to +18 dB.

Either turn the MASTER VOLUME dial on the main unit or

use the VOLUME buttons on the remote control unit to

adjust the volume.

M.VOLUME -20

VOLUME

Main unit

Remote control unit

The volume level is displayed

on the display.

•“DIG” lights when digital signals are input properly. If “DIG” is

flashing, check whether the connections are proper and whether

the input component’s power is on.

Input mode display

• In the AUTO mode

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

One of these lights, depending on

the input signal.

Lit

Input signal display

• DOLBY DIGITAL

• DTS

• PCM

Input mode when playing CD sources

• When playing CDs containing recordings of live concerts, etc., in

the “AUTO” mode, the sound may be slightly broken at the

beginning. If this happens, switch to the “PCM” mode.

Input mode when playing DTS sources

• If DTS-compatible CDs are played in the “PCM” mode, noise is

output because DTS playback is not possible.

To play a DTS-compatible source, be sure to set the input mode

to “AUTO” or “DTS”.

• Noise may be generated at the beginning of playback and while

searching during DTS playback in the AUTO mode. If so, play in

the DTS mode.

MENU/ SET

Main unit

SURROUND / SELECT

PUSH

PARAM.

Main unit

STAT U S

Remote control unit

2 To check the currently playing program source, etc.

Press the MENU/SET button. Display “STATUS” then turn

the SURROUND/SELECT control.

To perform this operation on the remote control unit, press

the STATUS button.

The current program source and surround settings are shown

on the display each time the button is pressed or turned.

(When the function is set to DVD, the information is also

displayed on the TV screen.)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 111 112

Comments to this Manuals

No comments

Denon ADV-M71 User Manual Page 44

Comments to this Manuals

Related products and manuals for Acoustics Denon ADV-M71