Denon AVR 2805 - AV Receiver Operations Instructions download pdf (Page 23)

Start the measurements.

Measurement of each channel is performed as folk)ws.

Display

c sw SL

÷ 1 Only the front speakers (A) is measured. Even if the front speakers (B)

is set, the setting automatically switches to the front speakers (A) once

measurements are completed.

÷2 Subweofer speaker is measured twice.

•_3 When "ZONE2" is selected, this is net displayed.

After each channel is measured, "Calculating" appears.

The display switches to Auto Setup check screen automatically.

1-I. Auto Setup

I [&_lli [,]#1FIB fl_lz.]I /1_.!

i_ril_l"i'i]l IN

Step: 1/9

_Cancel4

I-I. Auto Setup

Step:9/9

NOTES:

• Measurement is canceled when MASTER VOLUME

is operated while the Auto Setup is performed.

• Set the volume to halfway and set the crossover

frequency to the maximum or Low pass filter off if

your subweefer speaker can adjust the output volume

and the crossover frequency.

1-1. Auto Setup

_Speaker Config. Check

Delay Time Check

Channel Level Check

Store4

Retry 4

Cancel_

Remeasurement starts automatically te receive proper result ef measurement.

Remeasurement is performed to 2 times, and "Retry1 " or "Retry2" is displayed on screen during

remeasurement.

1-1. Auto Setup

ll'lllil! IN

Step: 1/9

_Cancel4

These error screens will be displayed when performing the measurements ef Auto Setup / Room EQ and the automatic measurements can net

be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the

pertinent items, and measure again.

When there is tee much noise in the room, the speakers may net be detected properly. Should this happen, perform the measurements when

the noise level is low, or switch off the power ef the equipment that is [)reducing the noise for the duration of the measurements.

:1 This screen will be displayed when the speakers required for

producing suitable reproduction have not been detected.

• The front L and front R speakers were not properly detected.

• Only one channel of the surround speakers was detected.

• Sound was output from the R channel when only one surround

back speaker was connected,

• The surround back was detected, but the surround speaker was

net detected,

Check that the pertinent speakers are properly connected.

(see page 13)

1-1. Auto Setup

_11_ I1

II!lltllo]t, il

_4Front

ILWB

Retry4

Cancell

2_, This screen will be displayed when the speaker polarity is

connected in reverse.

Check the polarity of the

pertinent speakers.

For some speakers, the

screen below may be

displayed even though

the speakers are properly

connected.

If so, select "Skip_l".

1-1. Auto Setup

"lL:lltll0]lll

_4Front

Retry4

Cancel_

Skip4

:3) This screen will be displayed when accurate measurements

cannot be made due to the input level to the microphone being to()

high.

Set up the speakers so that their position is farther away from

the listening position.

Lower the volume of the subwoofer speaker.

1-1, Auto Setup

_Exit

:4: This screen will be displayed when the measurement microphone

is not connected, or when all ef the speakers have net been

detected.

Connect the measurement microphone to the microphone

connector.

Check the speaker connections.

1-1. A_tup

isr_

Retry4

Cancel4

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 98 99

Comments to this Manuals

No comments

Denon AVR 2805 - AV Receiver Operations Instructions Page 23

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR 2805 - AV Receiver