Denon AVR-X3000 Owner's Manual download pdf (Page 157)

157

Appendix

TipsPlaybackConnections

Contents

Front panel Display Rear panel IndexRemote

Settings

Error messages

An error message is displayed if Audyssey® Setup could not be completed due to speaker placement, the measurement environment, etc. If an error

message is displayed, check the relevant items and perform the necessary measures. Be sure to turn o the power before checking speaker connections.

Examples Error details Measures

Microphone or Speaker is

None

•Setup and measurement microphone is not

detected.

•Not all speakers could be detected.

•Connect the included Setup and measurement microphone to the

SETUP MIC jack of this unit.

•Check the speaker connections.

Ambient noise is too high or

level is too low

•There is too much noise in the room.

•Speaker or subwoofer sound is too low.

•Either turn o any device generating noise or move it away.

•Perform again when the surroundings are quieter.

•Check the speaker installation and the direction in which the

speakers are facing.

•Adjust the subwoofer’s volume.

Front R : None •The displayed speaker could not be

detected.

•Check the connections of the displayed speaker.

Front R : Phase •The displayed speaker is connected with

the polarity reversed.

•Check the polarity of the displayed speaker.

•For some speakers, this error message may be displayed even if

the speaker is properly connected. If you are sure the connection is

correct, use p to select “Skip Error”, then press ENTER.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 231 232

No comments

Denon AVR-X3000 Owner's Manual Page 157