Denon AVR-X3000 Owner's Manual Page 163

  • Download
  • Add to my manuals
  • Print
  • Page
    / 232
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 162
163
Appendix
TipsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Settings
Crossovers
Set the maximum frequency of the bass signal output from each channel to
the subwoofer. Set the Crossover Frequency to suit the bass reproduction
capability of the speaker being used.
2 Speaker Selection
Selects how to set the crossover frequency. See the speaker manual
for information concerning speaker crossover frequency.
All (Default) : Selects the crossover point of all speakers at the same
time.
Individual : Selects the crossover points for each speaker individually.
2 Set the crossover frequency
40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz /
200Hz / 250Hz
%
•“Crossovers” can be set when the “Subwoofer Mode” (vpage164)
setting is “LFE+Main”, or when you have a speaker that is set to “Small”.
•The default crossover frequency is “80Hz”, which will work best with the
widest variety of speakers. When using very small speakers, however, you
can choose a higher setting based on the specified frequency response of the
speakers. If the speaker has a specified frequency response of 120 Hz – 20
kHz (as an example), then choose the 120 Hz crossover frequency.
•For speakers set to “Small”, low frequency content below the crossover
frequency is attenuated to the speakers and the low bass content is then
re-delivered to the subwoofer, or the front (L/R) speakers if they have been
set to Large.
•The speakers that can be set when “Individual” is selected dier depending
on to the “Subwoofer Mode” (vpage164) setting.
•When “LFE” is selected, speakers set to “Small” at “Speaker Config.”
(vpage160) can be set. If the speakers are set to “Large”, “Full Band” is
displayed and the setting cannot be made.
•When “LFE+Main” is selected, speakers can be set regardless of the
“Speaker Config.” (vpage160) setting.
Page view 162
1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 231 232

Comments to this Manuals

No comments