Denon AVR-5800 Operations Instructions download pdf (Page 19)

Setting the type of speakers

• The composition of the signals output from the different channels and the frequency response are adjusted automatically according to the

combination of speakers actually being used.

At the System Setup Menu select “Speaker Configuration”.

Switch to the speaker configuration screen.

Set whether or not speakers are

connected and, if so, their size

parameters.

• To select the speaker

• To select the parameter

Center Sp.

Front Sp.

Subwoofer

Surround Sp. A

Surround back Sp.

Surround Sp. B

Press “CURSOR/PAGE” at the center of the bottom line on the “AV AMP’s” “SETTING 3/5” page so

that this part is displayed in half-tone dot mesh.

Make the system setups by pushing the jog stick on the remote control unit forward and backward, left

and right.

Enter the setting.

a) If no surround speakers are used (if “None” is set for both A and B):

The System Setup Menu reappears.

b) If both surround speakers A and B are used (if either “Large” or “Small” is set for both A and B):

The surround speaker setting screen appears.

c) When “Front” is set to “Large” and “Subwoofer” is set to “Yes”, the set switches to the subwoofer mode.

d) If “None” is set for surround speakers A:

“None” is automatically set for surround speakers B and surround back speaker.

NOTE:

• Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency

(approximately 80 Hz and below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level low

enough so as not to damage the speakers) to determine the proper setting.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 111 112

No comments

Denon AVR-5800 Operations Instructions Page 19